CHAPTER 3
55
3.3.9
EXITING THE SETUP / CALIBRATE MENU
To Exit the Setup / Calibrate Menu:
Press the
PWR / MENU
button once to exit the
Setup / Calibrate
Menu and return to the
Program Main Menu. Press the
PWR / MENU
button twice to go directly to the normal
operating mode.
Note:
Pressing the
PWR / MENU
button before pressing the
ENTER
button will cancel that configuration change.
Note:
If the
PWR / MENU
button is held too long the meter will display all 8’s and the meter will
turn off.
3.4 SEQUENCING
CHANNELS
The V600 electronics makes it possible for a truck to haul various types of Vulcan VSL equipped
trailers with “plug in and go” ease. To do this, the VSL Vulcoders need to be assigned their position
(Channel A, B, C, or D) in the scale system. Once the Vulcoder has been assigned its position, it will
remember it and the process of sequencing does not need to be repeated, unless the position of the
Vulcoder changes. Sequencing is the process in which the meter determines the order of each VSL
Vulcoder or groups of load cells. For example, on a long logger, the meter reads the Front VSL
Vulcoder and assigns it as Channel A, and then reads the next VSL Vulcoder as a Rear and assigns
this VSL Vulcoder as Channel B.
For example, if
“<FrFr>”
is shown on the display, this would indicate that four Vulcoders were
detected. “
F
” indicates a front VSL Vulcoder and “
r
” indicates a rear VSL Vulcoder. The associated
channels will also be displayed.
Note:
On
new
installations, the system will make an attempt to automatically sequence the Vulcoders.
If the attempt
is not
successful (i.e. more than one Front or Rear Vulcoder is hooked up when the
meter is turned on) an Error code will be displayed (i.e. Err 03, Err 07, Err 08, or Err 09). If this
happens then the system will have to be
Manually Sequenced
.
June 21, 2006
VULCAN ON-BOARD SCALES 1-800-237-0022
Doc. 44-10032-001 Rev. C
©
STRESS-TEK, INC. 2006