7.8 Reinstalling Exterior Cabinet Panels
Once the cabinet rack space is configured as desired, the exterior cabinet panels
may be reinstalled. Refer to Figure 7–2 and reinstall the exterior cabinet panels
as follows:
1. Position a side panel against the cabinet with the lip above the upper hanger
clips just over the upper edge of the side of the cabinet.
2. Ensure that the entire surface of the side panel rests firmly against the side
of the cabinet.
3. Allow the panel to slide downward, catching the three hanger clips as it
moves.
4. Install the side panel bolts into the side panel through the holes in the top
side rails of the cabinet.
5. Repeat steps 1 through 4 to install the other side panel.
6. Locate the four inset nylon snap fasteners on the top cabinet rails.
WARNING
The top cover is heavy and awkward to lift. Installing it is a two-
person task. Failure to use sufficient personnel may result in injury or
equipment damage.
7. Position the top cover over the cabinet. Position the cover as shown in
Figure 7–2 such that the end of the panel with the shorter overhang is
oriented toward the front of the cabinet.
8. Align the pins on the underside of the top cover with the inset nylon fasteners
on the top cabinet rails.
WARNING
Be careful not to catch your fingers between the cabinet and the top panel
when snapping the panel to the cabinet.
9. Lower the cover onto the cabinet and press it down, ensuring that the pins
snap into the top panel fasteners.
10. If the cabinet was moved to access the side panels, place it in its original
position.
7–14 Installing TZLX-Series Tape Drives
