1. Move the cabinet away from adjacent enclosures as necessary.
2. Loosen the top cover by pushing up on its front and rear edges until it snaps
free of its fasteners.
WARNING
The top cover is heavy and awkward to lift. Removing it is a two-
person task. Failure to use sufficient personnel may result in injury or
equipment damage.
3. Using two persons, lift the top cover from the cabinet and set it aside.
4. Remove the bolts attaching the side panels to the top side rails of the cabinet.
5. Grasp a panel along its front and rear edges and lift up until the hanger clips
disengage. Lift the panel away from the cabinet.
6. Repeat the previous step to remove the other panel.
6.3 Installing the Shelves
Shelf bracket installations for front and rear shelves are shown in Figures 6–2
and 6–3. Using the illustrations as a guide, install shelf brackets as follows:
WARNING
Cabinet rail edges may be sharp and can slice or abrade skin or cable
insulation.
Note
Two small ESD grounding posts are provided with the cabinet. One is
located on a front vertical cabinet rail, and one on a rear rail. Should an
ESD grounding post interfere with the installation of a shelf, move the
post out of the way to any free hole on the cabinet.
1. Turn the cabinet power off as described in Section 6.1.
2. Determine the correct shelf mounting locations and corresponding cabinet rail
mounting holes for the shelf bracket. Refer to the chapter in this document
pertaining to your specific cabinet configuration for this information.
3. Position the shelf bracket at the correct mounting holes just behind the outer
flange of the vertical cabinet rail, as shown.
4. Using the shelf bracket as a template, mark the two U-nut mounting holes on
the inner flange of the cabinet rail.
5. Remove the shelf bracket and install two U-nuts along the inner flange of the
cabinet rail at the holes marked in step 4.
6. Position and fasten the shelf bracket to the outer flange of the cabinet rail
with two screws, as shown.
7. Fasten the bracket to the U-nuts with two screws.
Installing StorageWorks Shelves 6–3
