Note
To ensure proper alignment of the chassis rail assembly, use care to
position the round standoffs in the correct front and rear chassis rail
locating holes.
3. From the front of the cabinet, position the chassis rail assembly at the correct
mounting holes, as shown. Ensure that the rail bracket is positioned toward
the front of the cabinet, and that the arrow on the rail bracket points up.
4. Insert the rear round standoff into the rear chassis rail locating hole.
5. Support the chassis rail against the rear vertical cabinet rail and maintain
the rear round standoff in its locating hole. Extend the rail bracket to insert
the front round standoff into its correct front chassis rail locating hole.
6. Using the shelf bracket as a template, mark the four U-nut mounting holes
on the inner flanges of both the front and rear vertical cabinet rails. Make
sure to use the correct set of holes in the chassis rail.
7. Temporarily remove the chassis rail assembly and install four U-nuts along
the inner flanges of the front and rear vertical cabinet rails at the holes
marked in step 6.
8. Reposition the chassis rail assembly as directed in steps 3 through 5.
9. Fasten the chassis rail to the inner flanges of the front and rear vertical
cabinet rails with four screws, as shown.
10. Fasten the rail bracket to the front vertical cabinet rail with its beveled nut
bar and three screws, as shown.
11. Fasten the chassis rail to the rear vertical cabinet rail with its beveled nut
bar and three screws, as shown.
12. Tighten the screws fastening the rail bracket to the chassis rail.
13. Install two U-nuts along the outer flange of the front vertical cabinet rail.
Install one U-nut at the hole just above the front chassis rail locating hole
and the other at the eighth hole below the locating hole.
7.3.3 Left Position Chassis Rail Assembly Installation
Note
Install the chassis rail assembly in the left mounting position only if
a tape drive is also installed in the right position. The front cabinet
door tape bezel openings are designed to allow a single tape drive to be
installed only in the right position.
Install the chassis rail assembly in the left position within the cabinet as follows
(see Figure 7–5):
WARNING
Cabinet rail edges may be sharp and can slice or abrade skin or cable
insulation.
Installing TZLX-Series Tape Drives 7–7
