6.2 Accessing the Cabinet Rack Space
In maximum configurations where access to the interior of the cabinet is limited,
external cabinet panels may need to be removed before shelves can be installed
or reconfigured. Section 6.2.1 presents procedures for removing exterior cabinet
panels.
The front and rear cabinet doors are held closed by locks mounted near the top
and bottom of each door. The locks are released by turning them counterclockwise
with a 5/32-inch hex wrench.
6.2.1 Removing the Exterior Cabinet Panels
As shown in Figure 6–1, there are two side panel hanger clips on each side of the
cabinet. A matching set of hanger clips are attached to each side panel. Remove
the side panels as follows:
Figure 6–1 Exterior Cabinet Panel Removal and Installation
LOWER
SIDE PANEL
HANGER
CLIP
SIDE PANEL
TOP COVER
M6x40mm BOLT
(4 PLACES)
CXO-3899A-MC
SIDE PANEL
HANGER
CLIPS
CABINET
FRONT
FASTENER
PIN
(4 PLACES)
NYLON SNAP
FASTENER
(4 PLACES)
UPPER
SIDE PANEL
HANGER
CLIP
LIP
NOTE: FRONT AND REAR DOORS NOT SHOWN FOR CLARITY
6–2 Installing StorageWorks Shelves
