Stoll CMS 502 HP+, Operating Instructions Manual

Page: 232 / 562

232
4
Adjusting knitting machine
Advanced adjustments
Checking the braking values with the adjusting program
Checking the braking values
with the adjusting program
An adjusting program is available for controlling the stopping positions. An
ornamental stitch line is knitted with all the Intarsia yarn carriers used in the
pattern for you to be able to check the correct stopping position quickly and
easily.
When creating the intarsia pattern on the M1plus (starting with version 5.3 or
higher) you specify that the adjusting program is to be integrated in the pattern.
For this purpose activate the "Generate adjusting program" check box
("Pattern parameters" -> "Configuration" -> "Intarsia tab" -> "Valuate braking
values for Intarsia yarn carriers" section).
On the knitting machine you run the adjusting program before or also during
the production.
What is the structure of the
adjustment program?

All the intarsia yarn carriers, which are used in the pattern and swivel, are
included in the adjustment program.

Depending on the number of yarn carriers and the fabric width, the intarsia
yarn carriers will be distributed on one or more partial programs.

Program start: Set the cycle counter "RS39" ("RS18" with Setup1) to "1"
After the program start the "RS39" is automatically set to the value "99" to
ensure that a sufficient number of knitting rows is knitted for the
adjustment of the yarn carriers.

Proceed to the next partial program: with the "ctrl W" key

Program end: set with the "ctrl W" key or the cycle counter "RS39" to "0".
1 Adjustment program
Part 1
3 Embroidery stitch lines of the intarsia
yarn carriers
(vertical line, one needle wide)
2 Adjustment program
Part 2
4 Pattern