Still FM-X, Original Instructions Manual

Page: 114 / 292

5
Operation
Lifting
1
2
2
Reach-lower lock (variant)
The reach-lower lock prevents the load forks
from being lowered between the load wheel
posts whenever the reach carriage is in the
retracted position. As a result, wide loads
cannot accidentally come to rest on the load
wheel posts during lowering and become
unstable. The driver can override the cut out
by pressing the acknowledge button (1) or by
pressing shift button "F" (2).
Placing loads down on the ground
– Lower the fork carriage to the interlock.
– Extend the reach carriage in the load
direction to the stop.
– Fully lower the fork carriage.
When the reach carriage is fully extended, the
fork carriage can be lowered fully without the
interlock. It is not then possible to retract the
reach carriage. This prevents the load from
being "stripped". The driver must first lift the
load "free" again (to a height greater than 400
mm) or override the cut out by pressing the
acknowledge button.
Overriding the reach and lower cut out by
pressing the acknowledge button:
• Press the acknowledge button (1) to over-
ride the cut out.
Overriding the reach and lower cut out by
pressing shift button "F":
• Move the joystick or the relevant fingertip
switch to the zero position. Within one
second press shift button "F" (2) and release
it again to override the cut out.
If shift button "F" is not pressed within one
second and then released, the default
function of the shift button is restored
automatically.
104 50988078001 [EN]