ECG and Heart Rate Monitoring
élance
Vital Signs Monitor Operations Manual
Page 7-6
Lead Selection
Electrode Differential
Electrode Differential
(AAMI)
(IEC)
I
RA LA
R L
II
RA LL
R F
III
LA LL
L F
V (Chest Lead)
(RA+LA+LL)/3 Chest (V)
(R+L+F)/3 Chest (C)
AVL
(Lead I - Lead III)/2
(Lead I - Lead III)/2
AVR
- (Lead I + Lead III/2)
- (Lead I + Lead III/2)
AVF
(Lead II + Lead III)/2
(Lead II + Lead III)/2
4.
Touch
the
OK k
ey
to confirm.
is stored for full disclosure or multi ECG lead capture in which all
CG leads are stored for full disclosure. To use multi ECG lead capture you should
se a 5-Lead Cable and set ECG Cables to be 5 in
Setup Waveforms Window.
. 3-Lead Cable:
to ensure
n
the
lance
bedside monitor.
2. 5-Lead Cable:
Either single ECG lead capture or multi ECG lead capture is available with a 5-lead
cable. Single ECG lead capture can be obtained by displaying a single lead I, II or III
on the
élance
bedside monitor as with a 3-Lead Cable. Multi ECG lead capture can
be enabled with any lead combination in which one or more leads are displayed on the
élance
bedside monitor.
.
7.5 Set Waveform Size
The
disp
Each ECG waveform provides a 1mV scale size reference indicator at the left end of
the displayed ECG trace, the size of this corresponds to the size selection of the ECG
waveform in the ECG Setup. This shall be used as a reference to determine whether
the amplitude of the ECG waveform exceeds the minimum voltage threshold.
1.
2.
Note:
Full Disclosure can be utilized in two modes: single ECG lead capture in which only
one lead of ECG
E
u
1
Only single ECG lead capture is appropriate with a 3-Lead Cable in order
good signal quality. The lead choices are I, II or III with one ECG lead displayed o
é
ECG waveform size enables you to adjust the amplitude of an ECG waveform
layed on the
élance
Vital Signs Monitor.
S
TEPS
:
Touch
the
ECG Numerical Area
.
A Setup ECG window will appear.
Touch
the
Size
key
.
A dropdown list, as shown below, will appear.
