6-55
DMS-B150L/B210S/B80L/B110S/EX150L/EX210S
6-10. Setting the Switches
When removing the bin assembly, set the switches on the
CB-105 board in order to mount the drive in the upper
drive stage.
Set the switches as follows.
(This job is not necessary for the models supporting
Package.)
1. Removing the AMP panel
1.
Loosen the two screws (with drop-safe) and remove
AMP panel in the direction of the arrow.
n
These screws have drop-safe washers. Do not remove
the screws forcibly.
1
2
3
4
5
6
7
8
A
B
C
D
S1
S2
( indicates the knob position)
ON
1 2 3 4
5 6 7 8 9 10
2. Setting the switches (CB-105 board)
m
.
Do not change the settings of the switches shown as
“factory use only”.
.
The number in parentheses ( ) in the Ref. No. column
indicates the address on the circuit board.
S2 (B-5) : Drive setting switch
Function
ON
OFF
S2-1
Drive
1
setting
*
3
Set
Not set
S2-2
Drive
1
+
2
setting
Set
*
1
Not set
S2-3
Drive
1
+
2
+
3
setting
Set
*
2
Not set
S2-4
Drive
4
setting
Set
Not set
S2-5
Drive
5
setting
Set
Not set
S2-6
Drive
6
setting
Set
Not set
S2-7
Drive
7
setting
Set
Not set
S2-8
Drive
8
setting
Set
Not set
S2-9
Drive
9
setting
Set
Not set
S2-10 Factory use only
*
1 : When the switch S2-2 is desired to set to ON, be sure to set S2-1 to ON
at the same time
*
2 : When the switch S2-3 is desired to set to ON, be sure to set S2-1 and
S2-2 to ON at the same time
*
3: Setting the drive here means that area
1
in the table is changed from
the bin area into the drive installation area.
The default setting when shipped from the factory is as fol-
lows.
n
Even when the tape drive is actually not installed, be sure
to set the driver setting switch when removing the bin
assembly for installing the tape drive.
Screws
(with drop-safe)
AMP panel
Pins
6-10. Setting the Switches
