6-35
DMS-B150L/B210S/B80L/B110S/EX150L/EX210S
n
Fix the cable carefully so that the cable must not contact
with the synchro shaft or frame’s side panel.
.
Synchro shaft side :
The cable must be positioned
closer to the Y rail side than the
end surface A of the X cable
bracket (EXD).
.
Frame side panel’s side : The cable must be positioned
within 40 mm from the Y
harness bracket (1).
7.
Check tha the cables are not overlapped inside the
runner flex.
8.
Move the runner flex near the end of the second
extension console. Then push the four cables out to the
drive stage side from the hole of the guide channel (3)
assembly.
9.
Fix the metal plate of the runner flex with the two
screws (PWH 4
x
12).
10. Connect the five connectors of the cable to the mating
connector of the cable relay plate (EXD).
11. Fix the cable with the locking adjust clamp so that the
cable must not move to near the runner flex side than
A and B.
X cable bracket
A
Synchro shaft
Frame side panel
40 mm
Y rail
Y harness bracket (1)
PWH4
x
12
Hole of the guide channel
(3) assembly.
Runner flex
Connectors
Cable relay plate (EXD)
A
B
Runner flex
Guide channel (3)
assembly
Cable relay plate
(EXD)
Locking adjust clamps
6-6. Installation of DMSA-CBL1
