6-22
DMS-B150L/B210S/B80L/B110S/EX150L/EX210S
8. Installing the X Belt
1.
Route the X belt between the synchro shaft and X belt
pulley (top)/(bottom).
m
(1) Prepare the X belt that corresponds to the number of
extension consoles to be connected and cut the mark
position on the X belt with nippers as follows.
(This job is not necessary for the models supporting
Package.)
Repaired parts and printed pattern cutting
position
.
When a single extension console is going to
connect
Extension belt kit DMSA-BLT2
Cutting at the EX1 marking position.
.
When two extension consoles are going to
connect
Extension belt kit DMSA-BLT2
No cutting for the marking position is required.
.
When three extension consoles are going to
connect
Extension belt kit DMSA-BLT6
Cutting at the EX3 marking position.
.
When four extension consoles are going to
connect
Extension belt kit DMSA-BLT6
Cutting at the EX4 marking position.
.
When five extension consoles are going to
connect
Extension belt kit DMSA-BLT6
Cutting at the EX5 marking position.
.
When six extension consoles are going to
connect
Extension belt kit DMSA-BLT6
No cutting for the marking position is required.
11. Remove the six hexagonal head cap bolts (M3
x
12)
connecting the X belt (top), six spring washers and six
washers. Remove the X belt (top) from the belt fixing
panel (X).
12. Remove the six hexagonal head cap bolts (M3
x
12)
connecting the X belt (bottom), six spring washers and
six washers. Remove the X belt (bottom) from the belt
fixing panel (X).
6-5. Connecting Extension Consoles
M3
x
12
M3
x
12
SW3
SW3
W3
W3
Belt fixing panel (X)
Fixing belt (X)
X belt
Marking position
Nippers
Cut the valley of the belt tooth.
