animeo KNX 4 DC Motor Controller
28.02.2019
WM 24 V DC
2019 Somfy Activités SA
Ref. 5147817A
34/56
•
On and Off
If the object value is “1” or “0”, this is transmitted cyclically. If the object value changes by flank change at the
local input or with reception of a telegram, the current object value is transmitted cyclically.
6.6.6 Cyclic sending
Default value:
5 seconds
Selection options:
1
– 3600 seconds
With this parameter the time intervals are defined in which the corresponding object value should be trans-
mitted cyclically.
H
Please beware that cyclical supervision time of the receiver is approximately 4 times higher than that of
the transmitter.
6.7
Menu index card “Binary inputs – 8-Bit value (rising edge)”
6.7.1 Basic Function
Selected option:
8-Bit value (rising edge)
6.7.2 Contact type input A
Default value:
0
Selection options:
0
– 255
With this parameter the value is set which is transmitted with a rising edge to the local input A.
6.7.3 Contact A value on rising edge (0-255)
Default value:
Normally open
Selection options:
Normally open
Normally closed
With this parameter it is defined which contact type is at the local input A.
Normally open: The contact at the local input is activated closed and not activated opened.
Normally closed: The contact at the local input is activated opened and not activated closed.
