![background image](http://html1.mh-extra.com/html/smc-networks/8708l2/8708l2_management-manual_1300245072.webp)
C
ONFIGURING
THE
S
WITCH
3-20
CLI
– Enter the following command.
Setting the Switch’s IP Address
An IP address may be used for management access to the switch over your
network. By default, the switch uses DHCP to assign IP settings to VLAN
1 on the switch. If you wish to manually configure IP settings, you need to
set an IP address and subnet mask that is compatible with your network.
You may also need to establish a default gateway between the switch and
management stations that exist on another network segment.
You can manually configure a specific IP address, or direct the device to
obtain an address from a BOOTP or DHCP server. Valid IP addresses
consist of four decimal numbers, 0 to 255, separated by periods. Anything
outside this format will not be accepted by the CLI program.
Command Attributes
•
Management VLAN
– ID of the configured VLAN (1-4093). This is
the only VLAN through which you can gain management access to the
switch. By default, all ports on the switch are members of VLAN 1, so
a management station can be connected to any port on the switch.
However, if other VLANs are configured and you change the
Management VLAN, you may lose management access to the switch.
In this case, you should reconnect the management station to a port
that is a member of the Management VLAN.
Console#show bridge-ext
4-248
Max support VLAN numbers: 256
Max support VLAN ID: 4094
Extended multicast filtering services: No
Static entry individual port: Yes
VLAN learning: IVL
Configurable PVID tagging: Yes
Local VLAN capable: No
Traffic classes: Enabled
Global GVRP status: Disabled
GMRP: Disabled
Console#
Summary of Contents for 8708L2
