SMC Networks 8708L2, Management Manual

Page: 235 / 606

S
PANNING
T
REE
A
LGORITHM
C
ONFIGURATION
3-183
• Admin MST Path Cost – This parameter is used by the MSTP to
determine the best path between devices. Therefore, lower values
should be assigned to ports attached to faster media, and higher values
assigned to ports with slower media. (Path cost takes precedence over
port priority.) Note that when the Path Cost Method is set to short
(page 3-63), the maximum path cost is 65,535.
By default, the system automatically detects the speed and duplex
mode used on each port, and configures the path cost according to the
values shown below. Path cost “0” is used to indicate
auto-configuration mode.
•
Range –
- Ethernet: 200,000-20,000,000
- Fast Ethernet: 20,000-2,000,000
- Gigabit Ethernet: 2,000-200,000
- 10 Gigabit Ethernet: 200-20,000
• Default –
- Ethernet – Half duplex: 2,000,000; full duplex: 1,000,000; trunk:
500,000
- Fast Ethernet – Half duplex: 200,000; full duplex: 100,000;
trunk: 50,000
- Gigabit Ethernet – Full duplex: 10,000; trunk: 5,000
- 10 Gigabit Ethernet – Full duplex: 1000; trunk: 500