Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not permitted
unless authorised by
ŠKODA AUTO A. S. ŠKODA AUTO A. S. does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by
ŠKODA AUTO A. S.
�
– Carefully release retaining tabs -arrows- and pull off return ring
with coil spring -1- from the switch mounting on the steering
column.
Installing
Installation is carried out in the reverse order. When installing,
observe the following:
Note
♦
Vehicles manufactured as of CW 22/06 have no locking pin,
which could lock the restoring ring against unintentional turn‐
ing after removing the steering wheel. In case of doubt about
the correct positioning of the ring rotor, the middle position of
the return ring must be set before installing the steering wheel
⇒ page 144
.
♦
When installing, the return ring with coil spring must be in the
middle position and the wheels in the straight ahead position.
7.1.4
Removing and installing steering angle
sender - G85-
Note
♦
After replacing the steering angle sender - G85- subsequently
the basic setting must be carried out with the ⇒ Vehicle diag‐
nostic tester.
♦
Right-hand drive as of CW 22/08 and left-hand drive as of CW
22/09 - steering wheel sender - G85- integrated in the steering
gear
Removing
– Remove restoring ring with coil spring - F350-
⇒ page 135
.
– Detach steering angle sender -G85- -1- in
-direction of arrow-.
Installing
The installation occurs in reverse order.
7.1.5
Removing and installing lever key of
switch mounting on the steering column
Special tools and workshop equipment required
♦ Feeler gauge
Removing
– Remove restoring ring with coil spring - F350-
⇒ page 135
.
– Remove steering angle sender - G85-
⇒ page 136
(if present).
Octavia II 2004 ➤ , Octavia II 2010 ➤
Electrical system - Edition 12.2013
136
Rep. gr.94 - Lights, bulbs, switches - exterior
