Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not permitted
unless authorised by
ŠKODA AUTO A. S. ŠKODA AUTO A. S. does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by
ŠKODA AUTO A. S.
�
9.6.3
Gluing procedure of the sender holders
Note
♦
Vehicles up to MY 08 and all vehicles Octavia RS and Scout
- the sender holders have a submerged flange, its visible area
-1- must be painted in the colour of the bumper.
♦
Vehicles as of MY 09 (except for Octavia RS and Scout) - the
sender holders do not have a submerged flange -1-. Therefore
a centering pin must be used for precisely centering the holder
in the bumper or gluing the holder with inserted parking aid
sender on which the decoupling ring (black silicone ring) is
placed.
♦
The temperature of the bumper and the sender holder must
be between 15 °C and 30 °C during the gluing procedure.
– Clean and thoroughly degrease the marked adhesive area
-1- with isopropyl (technical alcohol).
– Evenly apply activator “3M glass/paint primer 4298UV”, if nec‐
essary, “gas/paint primer K520” in the marked adhesive area
-1-.
– Let the activator dry off for approx. 5 min.
Note
♦
Pay attention to the fitting position
⇒ page 154
and the as‐
signment of the sender holders
⇒ page 154
.
♦
The application force and the application time determine the
durability of the bonding!
– Remove the protective foils from both sides of the adhesive
tape and press the sender holder -2- into the front bumper for
approx. 10 seconds while applying high force.
9.7
Self-diagnosis of the parking aid
The parking aid system is equipped with self-diagnosis. Carry out
“self-diagnosis” with the ⇒ Vehicle diagnostic tester in the function
“Targeted fault finding”.
Octavia II 2004 ➤ , Octavia II 2010 ➤
Electrical system - Edition 12.2013
9. Parking aid
155
