Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not permitted
unless authorised by
ŠKODA AUTO A. S. ŠKODA AUTO A. S. does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by
ŠKODA AUTO A. S.
�
– Use a screwdriver to lever off the two caps on the wiper arms.
– Unscrew the nuts -arrows-.
– Push the extractor -2- for wiper arms -T10369/1- , as shown,
onto the arm.
Note
To release the windscreen wiper arms, always use the thrust
piece -3- in order to avoid damage to the thread of the wiper motor
shaft.
– Release the wiper arm -4- from the shaft by turning the pres‐
sure screw -1-.
Installing
Note
♦
When switching off for the second time, the wiper motor over‐
runs in the offset final setting so that the wiper blade lip is
controlled in the other direction.
♦
The wiper motor runs downwards and then again a little up‐
wards. This offset final setting cannot be used to compensate
for the windscreen wiper crank.
♦
The final setting must be used in which the wiper motor runs
directly and without overrun in the lower final setting. If the
wiper motor runs in the offset final setting, wiping must be
switched on again.
♦
Function of the offset final setting is active only after 100 wiper
cycles as of coding or installation of a new wiper motor. If this
function is already activated, it can be determined by switching
on and off the wiper motor repeatedly.
– Switch wiper motor on and off and run until it is in park position
for setting the windscreen wiper arms.
Octavia II 2004 ➤ , Octavia II 2010 ➤
Electrical system - Edition 12.2013
86
Rep. gr.92 - Windscreen wash/wipe system
