Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not permitted
unless authorised by
ŠKODA AUTO A. S. ŠKODA AUTO A. S. does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by
ŠKODA AUTO A. S.
�
Right-hand drive vehicles:
❑ installed under the front passenger seat
❑ installing and removing - vehicles up to MY 08 -
⇒ page 68
❑ installing and removing - vehicles as of MY 09
⇒ page 68
6.4
Removing and installing amplifier - R12-
(up to MY 08)
Removing
– Switch off all electrical components and take out the ignition
key.
Left-hand drive vehicles:
– Remove the driver's seat ⇒ Body Work; Rep. gr. 72 .
Right-hand drive vehicles:
– Remove front passenger seat ⇒ Body Work; Rep. gr. 72 .
Continued for all vehicles:
– Unclip clips -2-.
– Remove cover from amplifier.
– Disconnect connector -1-.
– Release nuts -arrows- (5,5 Nm).
– Remove amplifier.
Installing
Installation is carried out in the reverse order. When installing,
observe the following:
– When replacing, code the new control unit with the ⇒ Vehicle
diagnostic tester.
6.5
Removing and installing amplifier - R12-
(vehicles as of MY 09)
Removing
– Switch off all electrical components and take out the ignition
key.
– Push the left front seat completely towards the rear and the
highest point.
– Slightly raise the edges of the cover -arrows A- and pull out
the cover -arrow B-.
Octavia II 2004 ➤ , Octavia II 2010 ➤
Electrical system - Edition 12.2013
68
Rep. gr.91 - Radio, telephone, navigation
