Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not permitted
unless authorised by
ŠKODA AUTO A. S. ŠKODA AUTO A. S. does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by
ŠKODA AUTO A. S.
�
3.4
Removing and installing the lift cylinder
for spray nozzles of headlights - vehicles
as of MY 09
Removing
– Remove spray nozzle holder
⇒ page 95
.
– Remove front bumper ⇒ Body Work; Rep. gr. 63 .
– Press off the catches -arrows A- using a small screwdriver and
push the lift cylinder -1- out of the bumper -arrow B-.
Installing
Installation is carried out in the reverse order. When installing,
observe the following:
– Push the lift cylinder into the brackets in the bumper until it
clicks audibly into place.
– Observe correct mounting sequence of spray nozzle holder
⇒ page 95
.
– Hoses with angled pieces must click audibly into the connec‐
tions on the lift cylinders for spray nozzles.
– Install bumper.
– After completing the assembly work bleed the headlamp
cleaning system
⇒ page 96
.
3.5
Bleed the headlamp cleaning system
After installation or for initial setup, the headlamp cleaning system
must be bled to guarantee a perfect operation.
– Fill washer fluid reservoir and headlight washer reservoir.
– Start engine.
– Switch on headlight.
– Operate headlamp cleaning system several times (3 – 5 pul‐
ses for an operating duration of 3 s each).
– If necessary repeat this bleeding procedure until a perfect
functioning of the lift cylinders for headlamp cleaning system
and for spray nozzles is achieved.
Octavia II 2004 ➤ , Octavia II 2010 ➤
Electrical system - Edition 12.2013
96
Rep. gr.92 - Windscreen wash/wipe system
