Skanti TRP 9250, Technical Manual, Page: 68 / 289

Select Intercom.
When more than one Control Unit is connected the TRP 9250 can act as a normal
telephone with intercommunication between any two control units.After "Prog"
"10" "Enter" is pressed the display shows
Phone _
Enter "phone number" of the wanted Control Unit and press "Enter".The wanted
CU will start beeping until the handset is hooked-off.Normal intercommunication
in full duplex can now take place with all other control units muted.The Intercom
facility is automatically disabled first time the handset of the calling CU is
hooked-on, and the Transceiver returns to normal operation.Please refer to @@
Set Real Time Clock.
After "Prog" "11" "Enter" is pressed the Clock Display is cleared and the correct
time of day can be entered with the numeric keys.Press "STO" and the Real Time
Clock is started in the same moment.
Switch Treble Cut On/Off
During difficult atmospheric conditions and reception of weak signals, the
intelligibility of the received signal may deteriorate due to high frequency noise.
The Intelligibility may be greately improved by switching Treble Cut on during
these conditions. The Treble Cut may be selected individually on each TCU
connected.
Tilt Viewing Angle of Display.
To obtain the best possible legibility the viewing angle of the display may be
toggled between two positions by pressing "Prog" "13" "Enter".
Toggle Bar-graph Reading, Power or Amperes.
By pressing "Prog" "14" "Enter" it is possible to change the transmitter
Bar-graphdisplay between either power or antenna current.
Set Beep Level.
To adjust the keyboard Beep to a convenient level switch the loudspeaker on and
press "Prog" "15" "Enter". The keyboard Beep is constantly beeping and may be
adjusted to a convinient sound level by the "Volume up" and "Volume down" keys.
Press "STO" to store the new Beep level. Pressing "Enter" instead will maintain
the previous Beep level setting.
Select HST mode.
Pressing "Prog" "16" "Enter" will select High Speed Telex mode. This mode is
indicated by both the "SSB" and "TLX" annunciators in the display.
OPERATION RELATED ’PROG’ KEY OPERATIONS OPERATION
TRP 9250 TECHNICAL MANUAL 2-53