Skanti TRP 9250, Technical Manual, Page: 55 / 289

FREQUENCY SWEEPING, SET UP
Setting up the Sweep Program.
1. Press to start the programming.
The currently stored Sweep parameters are
displayed.
e.g. No parameters are stored.
2. Enter the number of the Trigger Source that you want
to use: 0 = no trigger source, 1 = squelch
2 = signal strength, 3 = squelch or signal strength,
4 = squelch and signal strength.
e.g. 2.
Press to store the Trigger Source.
Because signal strength is selected as Trigger Source
in this example, you must now set the sensitivity level.
3. Press or to adjust the
sensitivity level.
e.g. Sensitivity -80 dB.
Press to store the level.
4. Enter the Dwell Time which is the period in which the
receiver will "listen" for a signal on each frequency.
e.g. 2.5 seconds.
Press to store the Dwell Time.
OPERATION FREQUENCY SWEEPING, SET UP
2-40 TRP 9250 TECHNICAL MANUAL