Skanti TRP 9250, Technical Manual, Page: 132 / 289

View / change TCU Priority System
No.: 90 View / Change TCU Priority System
Enable/Disable Master Priority, Privacy and Exclusive Access in Multi-Control Unit system.
"1" enables the parameter
"0" disables the parameter
Default values shown below
Default values Receiver Display
TX Mode
Parameter
Master
Priority
Privacy
Exclusive
Access
Enable/Disable 0 0 0
The Priority System is adapted to various needs by configuration of three parameters:
EXCLUSIVE ACCESS
PRIVACY
MASTER PRIORITY
EXCLUSIVE ACCESS
By enabling/disabling this parameter it is selected whether the currently used TCU has Exclusive
Access to the transceiver with no interruption from other TCU’s possible, or that control can take
place from any CU at any time.
Exclusive Access Enabled:
Only key entries on the currently used TCU are executed. The "Busy" annunciator is flashing in the
display of all other TCU’s to indicate that the transceiver is in use.
When control from the currently used TCU no longer is needed, it is necessary to press "Prog" "0"
"Enter" (Leave System To Other User) to enable control transfer to another TCU. The "Busy"
annunciators is then switched off to indicate that the transceiver is no longer in use.
When the "Busy" annunciator is switched off in the display of a TCU, control can be transferred to
that TCU simply by pressing any key (preferably the "Enter" key). All other TCU’s are immediately
locked out and "Busy" is flashing in all other displays, indicating that the transceiver is now in use.
Exclusive Access Disabled:
Control is automatically transferred to the TCU where the last key entry was made. The "Busy"
annunciator is switched off in all TCU’s indicating that operation can take place on any TCU. (Busy
switched off in all TCU’s except when a Master Priority TCU is in use).
CONFIGURATION INSTALLATION
TRP 9250 TECHNICAL MANUAL 3-65