Skanti TRP 9250, Technical Manual, Page: 50 / 289

CHANNEL SCANNING, SET UP INFO
Scanning parameters:
Scanning annunciator
Selected sensitivity level
Programming annunciator
Scanning annunciator: Will be on during the programming.
Scan Program Number: 10 Scan Programs. Selectable from number 0 to number 9.
Trigger Source: Selectable with number 0 to 4. 0 = no trigger source, 1 = squelch,
2 = signal strength, 3 = squelch or signal strength, 4 = squelch and signal strength.
(5 to 9 will be defaulted to 0).
Number Of Channels to be scanned: The maximum number is depending on the currently
occupied scan memory, however not bigger than 99. Enter the required number and TRP 9250
will inform you if the available memory is too small, by flashing the number.
If you store a bigger number of channels than required TRP 9250 will reduce the alocated
memory to the actual need, after the scan table has been stored and then update the Number Of
Channels to be scanned to the actual number.
Insert extra channels: Add the number of extra channels to the current number and store the
new number as the Number Of Channels to be scanned. You may now store the new channels
at the end of the Scan Table.
Delete a number of channels from the end of the scan table: Subtract the number of channels
that you wish to delete from the current number and store the new number as the Number Of
Channels to be scanned.
Trigger Source
Scan Program Number
Number Of Channels
Transmitter display
Receiver display
Hold Time
Dwell Time
CHANNEL SCANNING, SET UP INFO OPERATION
TRP 9250 TECHNICAL MANUAL 2-35