Skanti TRP 9250, Technical Manual, Page: 238 / 289

SENDING AN ACKNOWLEDGEMENT, INFO
Selective calls and Direct-dial calls require acknowledgement.
If the call contains Polling, Ship position, or legal mode and Frequency information, transmission of
acknowledgement may be initiated by just pressing [Call]. Steps 2 to 5 are then automatically
performed.
If the call is a telephony call the same is obtained by just lifting the handset off hook.
When transmission is completed and if the acknowledgement contains mode information, the
transceiver is set to the mode and frequencies indicated in the acknowledgement call by pressing
[Enter] or, for telephony calls, lifting the handset off-hook within one minute..
END should be entered when communication is completed. For telephony calls just place the handset
on hook. The display returns to STATUS or to RX-CALL if not all received calls have been read out
and scanning is resumed on the transceiver if so selected.
Note: If the call is not acknowledged within 4.5 minutes ACK is replaced by >TX-CALL<. If this is
entered the information in the received call is transfered to a TX-CALL.
DSC OPERATION SENDING AN ACKNOWLEDGEMENT, INFO
6-46 TRP 9250 TECHNICAL MANUAL