Skanti TRP 9250, Technical Manual, Page: 282 / 289

INSTALLATION CONFIGURATION
The DSC 9000 is factory configured to standard settings, stored in a non-volatile EEPROM. Change
of these settings is possible from the front panel of the DCU 9000.
To view or change configuration settings, switch the equipment on, press [Main Menu], select
CONFIGURATION and press [Enter]. Select VIEW or CHANGE and press [Enter].
To protect against unintensional changes a password must be entered if CHANGE is selected. The
figures are not displayed while keyed-in.
Note: Following any change in configuration setting the supply must be switched off-on to implement
the changes.
Configuration of Self-ID
The Maritime Mobile Service Identity assigned to the station must be stored in the DSC 9000 before
it can be used.
Select SELF-ID in the CONFIGURATION menu and press [Enter]. Key-in the MMSI and press
[Enter].
To prevent the operator from changing the self-ID, it must be protected by entering PROTECT.
Please note that once PROTECT has been entered, change of self-ID is not possible (only after a
factory resetting. See page 3-47). Therefore, check the numbers carefully for correctness before
pressing [Enter].
Configuration of Group-ID
One or more group call identities may be assigned to the station. Group call identity numbers always
contains a leading zero. The group call identities assigned to the station must be stored in the DSC
9000 before it is able to respond to group calls. Up to six group call identity numbers may be stored.
Select GROUP-ID in the CONFIGURATION menu and press [Enter]. Key-in the group call identities
and press [Enter]. Check that the self-ID is correct after having switched the equipment off and on.
Configuration of Control Unit Priority
Where more control units are connected to a DU 9000 each control unit may be given a priority.
Only a control unit with higher priority can interrupt a control unit which is in any other state than
MAIN-MENU or STATUS states.
To change the priority level select PRIORITY in the CONFIGURATION menu and press [Enter].
Select the desired priority level (1. priority is the highest level) and press [Enter].
Note: If an external distress alarm button is connected to a control unit, this control unit should be
given priority
DSC INSTALLATION INSTALLATION CONFIGURATION
7-18 TRP 9250 TECHNICAL MANUAL