Skanti TRP 9250, Technical Manual, Page: 117 / 289

Use to store the same value again if no change is wanted, or use the numeric keys to change
the value and to store a change. If the Function has more than one parameter the flashing
bar will shift right to the next parameter. When the last parameter has been stored another Function
Number may be entered as described above. If is pressed instead, the Transceiver will
return to normal operation.
Some functions requires to be activated once, after a change has been made, in order to invoke
the reconfiguration. For example if Power Level is "Full" and Full Power is disabled by configuration,
the transmitter will stay on Full Power and next time Power Level is changed, only Medium and Low
are available.
Directly Executable Functions
Some Functions are directly executable and requires no storing of parameters.
Press "Function No."
The Function will be executed immediately and another Function Number may be entered. If
is pressed instead, the Transceiver will return to normal operation.
Functions:
Disable / Enable of keys
When a key is disabled no change will take place when pressed.
If the key has a toggle function (TX On/Off, "Light", etc.) select the wanted state with the key before
going to the Configuration Mode, disable the key by storing a "0" as the value of the parameter.
Press to return to normal operation. The key is now disabled and the state is stable
and not changeable.
Disabled keys can be enabled again by storing a "1" as a value of the parameter.
INSTALLATION CONFIGURATION
3-50 TRP9250 TECHNICAL MANUAL