Simplicity AGCO Allis 2000 Series, Service & Repair Manual

Page: 88 / 312

A
Figure 20. Instrument Panel Lamps Replacement
A. Instrument Panel
C. Lamp
B. Lamp Socket D. Lamp Bezel
C
INSTRUMENT PANEL LAMPS
The instrument panel warning/status lights are
illuminated by individual lamps. On 20 & 25 HP V-Twin
Tractors the lamps can be easily replaced without
removing the dashboard. The 20 HP Liquid-Cooled
Tractor and 24.5 Diesel Tractor may require the steering
wheel and dashboard to be removed to replace the
lamps.
The lamps are accessed from the back of the instrument
panel, (A, Figure 20). Replace lamps with the exact type
and rating to prevent damage to the instrument panel
and electrical system.
Refer to Section 8, POWER STEERING SERVICE, for
the procedure to remove the steering wheel and
dashboard if required.
A
D
B
7 Electrical System Service
Location and Replacement
7 - 20
Figure 19. Instrument Panel Replacement
A
Dashboard C. Screws
B. Instrument Panel D. Harness Connector
INSTRUMENT PANEL
The instrument panel (B, Figure 39) is located in the
dashboard (A) directly above the steering wheel. The
instrument panel contains the RPM gauge, temperature
gauge, and warning/status lights. Other than the light
bulbs, the instrument panel contains no replaceable
parts and is serviced as an assembly.
If necessary, refer to Section 8, POWER STEERING
SERVICE, for the procedure to remove the steering
wheel and dashboard before attempting to remove the
instrument panel.
1. Disconnect and secure the negative battery cable,
(see Section 6, COMMON SERVICE PROCE-
DURES).
2. Unplug the wire harness connector (D, Figure 19)
from the back of the instrument panel (B).
3. Remove the four screws (C) that are securing the
instrument panel to the dash.
4. Remove the instrument panel from the back of the
dash.
5. Install instrument panel in reverse order of removal.
C
C
B
A
Figure 21. Seat Switch Safety System
A. Seat Switch
C. Seat
B. Wire Harness
B
SEAT SWITCH
1. Disconnect and secure the negative battery cable,
(see Section 6, COMMON SERVICE PROCE-
DURES).
2. Tip the seat deck forward to access the bottom of the
seat assembly.
3. Disconnect the wire harness (B, Figure 21) from the
seat switch (A).
4. Remove the screws (A, Figure 22) and washers (B)
and then remove the switch assembly from the seat
pan.
5. Install seat switch in reverse order of removal.
A
C
C
Not
for
Reproduction