Simplicity AGCO Allis 2000 Series, Service & Repair Manual

Page: 38 / 312

3 - 14
Oil and Filter Change
Refer to Figure 23 for oil filter and dipstick locations.
To drain the oil:
1. Place a drain pan below the engine oil pan.
2. Remove the oil drain plug and allow the engine to
completely drain.
3. Remove and replace the oil filter.
4. Reinstall the oil drain plug.
5. Refill the engine oil. See the engine owner’s manual
for oil recommendations.
Check/Change Air Filter
Refer to the engine manual for specific air filter service
procedures. Refer to Figure 23 for air filter location.
Clean Radiator Screen
Clean the radiator screen before each use to allow
proper air flow through radiator and engine compartment.
1. Open the hood.
2. Open the latch (D, Figure 23) and slide the screen
(E) out.
3. Clean all dirt, grass, and debris from the screen.
Using compressed air, clean out the front and back of
the radiator.
4. Reinstall the screen.
Figure 23. Change Oil & Filter
A. Oil FIlter
D. Latch
B. Dipstick E. Screen
C. Air Filter
E
C
D
A
B
3 Maintenance
Maintenance – Diesel Engine Models
Check Antifreeze Level
The engine coolant level and quality should be checked
before each use, when the engine is off and cool.
1. Check the coolant level in the overflow reservoir (A,
Figure 24). Coolant should be between the “H” and
“L” marks on the tank.
2. If the coolant level is below the “L” mark on the over-
flow reservoir, add coolant by shutting off the engine,
allowing the engine to cool, removing the reservoir
cap, and adding coolant. Proper coolant mix is a
50/50 mixture of ethylene glycol based anti-freeze
and distilled water.
Change Antifreeze
Refer to the engine manual for specific antifreeze
procedures. The antifreeze drain valve is located at the
base of the left hand side of the radiator.
Figure 24. Check Antifreeze Level
A. Reservoir
A
Not
for
Reproduction