Simplicity AGCO Allis 2000 Series, Service & Repair Manual

Page: 86 / 312

7 - 18
7 Electrical System Service
Location and Replacement
COMPONENT LOCATION AND
REPLACEMENT
N
P
Figure 14. Dashboard Components
A
Dashboard D. Headlight Switch
B. Instrument Panel E. Ignition Key Switch
C. PTO Switch F. Height of Cut Switch
HEADLIGHT SWITCH
The headlight switch (D, Figure 14) is located in the
dashboard (A) on the left-hand side.
1. Disconnect and secure the negative battery cable,
(see Section 6, COMMON SERVICE PROCE-
DURES).
2. Unplug the wire harness (B, Figure 15) from the back
of the switch (C).
3. From behind the dashboard, push in the locking tabs
(D) and remove the switch as shown in Figure 35.
NOTE: Be careful to not press on the tabs that hold the
contact block to the switch rocker. The parts in the con-
tact block are very small and could get lost if separated.
4. Install headlight switch in reverse order of removal.
Figure 15. Headlight Switch Replacement
A
Dashboard C. Headlight Switch
B. Wire Harness D. Locking Tabs
B
3. Unplug the wire harness (B) from the back of the igni-
tion key switch (C).
4. Remove the cap (F) using a screwdriver or pliers.
5. Remove the key switch nut (E) from the switch.
6. Remove the switch (C) from the back of the dash-
board (A).
7. Reinstall ignition key switch in reverse order of
removal.
C
C
A
C
E
F
B
D
A
Figure 16. Ignition Key Switch Replacement
A
Dashboard E. Key Switch Nut
B. Wire Harness F. Cap
C. Ignition Key Switch G. Keys
D. Washer
G
A
A
F
E
C
D
C
B
NOTE: Most models do not require the dashboard to be
removed for component replacement or service. If it is
required, refer to Section 14, HOOD, DASH, & FOOT
REST SERVICE.
D
D
IGNITION KEY SWITCH
The ignition key switch is located in the dashboard on
the right-hand side of the steering wheel.
1. Remove the key (G, Figure 16) from the switch if not
already done so.
2. Disconnect and secure the negative battery cable,
(see Section 6, COMMON SERVICE PROCE-
DURES).
Not
for
Reproduction