Simplicity AGCO Allis 2000 Series, Service & Repair Manual

Page: 90 / 312

7 - 22
7 Electrical System Service
Location and Replacement
Figure 27. Circuit Breaker Replacement
A. Firewall
D. 30A Circuit Breaker
B. 20A Circuit Breaker E. Circuit Breaker Wire
C. Plastic Fastener F. Terminals
A
CIRCUIT BREAKER
The circuit breakers are located on the firewall in the
back of the engine compartment, see Figure 27, Items B
and D.
1. Disconnect and secure the negative battery cable,
(see Section 6, COMMON SERVICE PROCE-
DURES).
2. Disconnect the wires (E) from the circuit breaker ter-
minals (F).
E
E
B
D
F
F
C
Figure 26. Tail Light Lamp Replacement
A. Tail Light Bezel
C. Bulb
B. Socket D. Seat Deck
D
B
C
A
Figure 25. Headlight Lamp Removal and Replacement
A. Socket
C. Halogen Bulb
B. Headlight Bezel D. Wire Harness
C
B
A
D
HEADLIGHT LAMPS
1. Open the hood.
NOTE: For gas engine models, the forward heat shield
will need to be removed, (see Section 14, HOOD, DASH,
& FOOT REST SERVICE).
2. Remove the light bulb socket (A, Figure 25) from the
bezel (8) by twisting it counterclockwise and pulling it
out.
3. Use a rag or gloves to remove and replace the light
bulb (C) with an identical halogen bulb.
DO NOT
TOUCH THE BULB WITH YOUR BARE HANDS
.
4. Reinstall the socket (A) into the bezel (B).
TAIL LIGHT LAMPS
1. Twist the socket (B, Figure 26) counterclockwise and
pull out to remove it from the tail light.
2. Remove and replace the old bulb (C) with a new
identical bulb.
3. Reinstall the socket into the tail light bezel (A).
3. Remove the plastic fastener (C) securing the body of
the circuit breaker to the firewall (A) and remove the
circuit breaker.
4. Install circuit breaker in reverse order of removal.
NOTE: The circuit breaker posts are marked “BAT” and
“AUX.” The BAT post should be connected to the battery
via the solenoid. The AUX post should be connected to
the ignition switch.
Not
for
Reproduction