NC Commissioning with HMI Advanced
11.7 Digital and analog I/O devices
Manual
Commissioning Manual, 05/2008, 6FC5397–4CP10–4BA0
473
●
T
M
Master time: Offset of the start time for NC position control
●
GC
Global Control: Broadcast message for cyclic convergence of the equidistance between
DP master and DP slaves
●
R
Computational time of position controller or signal module
●
Dx
Useful data exchange between the DP master and DP slaves
●
MSG
Acyclic services (e.g. DP/V1, pass token)
●
RES
Reserve: "Active break" until the equidistant cycle has expired
●
①
Set the system variables, e.g. $A_OUT[8] in the part program or synchronized action
●
②
Transmit the output signal to the signal module via the PROFIBUS DP
●
③
Connect the signal to the output of the module.
11.7.6
Configuration example
In the following configuration example, the following digital input/outputs are available to the
NC:
ET 200
●
24 digital inputs
●
16 digital outputs
ADI4
●
8 digital inputs
●
16 digital outputs
Note
The following is to be taken into account:
•
The I/O addresses of the modules are assigned automatically by "HW Config" (manual
adjustment is possible).
•
Each I/O address is related to an input/output byte.
