Programming and Operating Manual (Milling)
12
6FC5398-4DP10-0BA1, 01/2014
Pressing this key approaches the magazine to the reference point
(active only in JOG mode).
LED on: The magazine is reference point approached.
LED off: The magazine is not yet referenced
Pressing this key rotates the magazine counter-clockwise (active only in
JOG mode).
LED on: The magazine rotates counter-clockwise.
LED off: The magazine stops counter-clockwise rotation.
Pressing this key in any operating mode starts the forward rotation of the
chip remover (active only in JOG mode).
LED lit: The chip remover starts forward rotation.
LED unlit: The chip remover stops rotation.
Keeping pressing this key in any operating mode rotates the chip
remover in reverse order. Releasing the key changes the chip remover
to the previous forward rotation or stop state (active only in JOG mode).
LED lit: The chip remover starts reverse rotation.
LED unlit: The chip remover stops reverse rotation.
Pre-defined insertion strips
The MCP (machine control panel) package includes two sets (six pieces each) of pre-defined insertion strips. One set is for
the turning variant of the control system and is pre-inserted on the back of the MCP. The other set is for the milling variant of
the control system.
If your control system is of the SINUMERIK 808D ADVANCED milling variant, replace the pre-inserted strips with the milling-
specific insertion strips.
