![background image](http://html.mh-extra.com/html/sick/mitsubishi-electric-melsec-iq-f-fx5/mitsubishi-electric-melsec-iq-f-fx5_user-manual_1264306066.webp)
64
4 FUNCTIONS
4.2 Built-In Program Selection Function
The details of the program 8 are as follows.
Two independent logic paths
Inputs/
sensors
A:
Single-channel N/C contact
Dual-channel equivalent N/C
contact (without cross-circuit
detection)
ESPE and sensors with
semiconductor output
B:
Single-channel N/C contact
Dual-channel equivalent N/C
contact (without cross-circuit
detection)
ESPE and sensors with
semiconductor output
OR
OR with FX5-SF-8DI4 (switch position 7)
AND
AND with FX5-SF-8DI4 (switch position 1 to 6)
Restart
interlock
Connection of X0:
• (1): Q0/Q1, with restart interlock, without EDM
• (2): Q0/Q1, without restart interlock, without EDM
• (3): Q0/Q1, with restart interlock, with EDM
• (4): Q0/Q1, without restart interlock, with EDM
Restart
interlock
Connection of X1:
• (5): Q2/Q3, with restart interlock, Q2 without EDM
• (6): Q2/Q3, without restart interlock, Q2 without EDM
• (7): Q2/Q3, with restart interlock, Q2 with EDM
• (8): Q2/Q3, without restart interlock, Q2 with EDM
Bypass
OR limited 60 seconds with FX5-SF-8DI4 (switch position 8)
ENABLE
Always wire ENABLE (XS0). (24 VDC is required.)
When the ENABLE is LOW, Q0 to Q3 are always LOW.
Off delay
Off delay acts only on Q3.
Retriggering
Connection of X2:
Q3, with/without EDM
• (9): Retriggering ON
• (10): Retriggering OFF
Outputs
Q0 to Q2, undelayed OSSDs
Q3, delayable OSSDs
A
B
+
I0
I1
+
I0
I1
I0
I1
+
I2
I3
+
I2
I3
I2
I3
FX5-SF-8DI4
FX5-SF-8DI4
FX5-SF-8DI4
FX5-SF-8DI4
+
X0
(1)
T0
X0
(2)
+
X0
(3)
T0
X0
(4)
+
X1
(5)
T1
X1
(6)
+
X1
(7)
T1
X1
(8)
FX5-SF-8DI4
FX5-SF-8DI4
XS0
T1
X2
(9)
(10)
+
X2
Q0
Q1
Q2
Q3
Summary of Contents for MITSUBISHI ELECTRIC MELSEC iQ-F FX5
