SICK MITSUBISHI ELECTRIC MELSEC iQ-F FX5, User Manual

Page: 135 / 176

APPX
Appendix 3 Checklist for Manufacturer
133
A
Appendix 3
Checklist for Manufacturer
The specifications in the following list must be available at least for the initial commissioning.
They are dependent on the application, whose requirement must be checked by the manufacturer/installer.
This checklist should be retained/stored with the machine documentation so that you can use it as a reference for periodical
tests.
This checklist does not replace a system commissioning and regular inspections by a mechanic who is qualified to carry out
safety inspections.
1.
Have the safety rules and regulations been observed in compliance with the directives/
standards applicable to the machine? Yes  No 
2.
Are the applied directives and standards listed in the declaration of conformity?
Yes  No 
3.
Does the protective equipment comply with the required category?
Yes  No 
4.
Are the required protective measures against electric shock in effect (protection class)?
Yes  No 
5.
Has the protective function been checked in compliance with the test notes in this
manual? Especially:
• Functional check of the command devices, sensors and actuators connected to the safety
extension module
• Test of all switch-off paths
Yes  No 
6.
Are you sure that the safety extension module was tested fully for safety functionality
after each configuration change?
Yes  No 