12
[PRÉCAUTIONS DE CONCEPTION]
ATTENTION
●
À la commande d'une charge inductive comme une lampe, un réchauffeur ou une électrovanne, un
fort courant (environ 10 fois supérieur à l'intensité normale) peut traverser la sortie quand celle-ci
passe de OFF à ON. Prenez les mesures appropriées pour que l’intensité de courant ne dépasse pas
la valeur correspondant à la spécification de charge maximale de la charge de résistance.
●
Mettez le module FX5 CPU et le module d’extension de sécurité sous tension en même temps (avec
moins de 2 secondes d’intervalle). Si une erreur de connexion se produit après avoir mis les deux
modules sous tension en même temps, vérifiez l’alimentation des deux modules.
Dans le cas où un même circuit serait utilisé pour alimenter le contrôleur programmable et un autre
appareil, il sera nécessaire de séparer le circuit afin de pouvoir mettre les appareils sous et hors
tension indépendamment.
Si une erreur de connexion se produit, vérifiez le code de l’erreur, puis mettez le module CPU et le
module d’extension de sécurité hors tension avant de remettre les deux modules sous tension en
même temps.
●
La catégorie de sécurité est définie par l’évaluation de l’équipement dans son ensemble. Procédez à
toutes les vérifications nécessaires avant d’utiliser l’équipement.
●
Afin d’éviter la génération de bruit et de chaleur, maintenez les distances suivantes entre les appareils
(contacteur, relais, etc.) et le contrôleur programmable, ainsi qu’entre les câbles des dispositifs
externes et d’alimentation et les câbles du contrôleur programmable.
• Distance entre les câbles : 100 mm ou plus
• Distance entre les appareils : 50 mm ou plus
●
Lorsqu’un contact mécanique, tel qu’un relais, est connecté à l’entrée du module d’extension de
sécurité, un cliquetis peut parfois entrer en tant que signal.
Summary of Contents for MITSUBISHI ELECTRIC MELSEC iQ-F FX5
