17
[PRÉCAUTIONS DE MISE EN SERVICE ET DE MAINTENANCE]
AVERTISSEMENT
●
Ne toucher aucune borne quand le contrôleur programmable est sous tension. Cela pourrait être à
l'origine d’électrocutions ou de dysfonctionnements.
●
Avant de nettoyer ou de resserrer les bornes, couper toutes les phases de l'alimentation externe.
Faute de quoi, il y a risque d'électrocution avec les bornes sous tension.
●
Avant d’effectuer une modification au programme en cours, une sortie forcée, ou une exécution ou un
arrêt du contrôleur programmable, lisez attentivement ce manuel et assurez-vous une sécurité
complète. Une opération erronée peut endommager la machine ou provoquer des accidents.
●
Ne pas modifier le programme dans le contrôleur programmable à partir de deux ou plusieurs
périphériques en même temps (c'est-à-dire à partir d'un outil d'ingénierie et d'un GOT). Cela pourrait
être à l'origine des destructions ou des dysfonctionnement du programme du contrôleur
programmable.
●
Utilisez un dispositif de sécurité adapté aux signaux de sécurité.
Les problèmes dans les fonctions liées à la sortie de sécurité peuvent provoquer une perte des
fonctions de sécurité et entraîner des blessures graves.
Ne connectez pas le produit à une charge supérieure aux valeurs nominales de la sortie de sécurité.
Branchez le module d’extension de sécurité de manière à ce que le courant continu de 24 V n’entre
pas en contact par erreur avec la sortie de sécurité.
Reliez la ligne de terre à la terre et de manière à ce que l’appareil ne se mette pas en tension lorsque
le câble de la sortie de sécurité entre en contact avec le potentiel de la masse.
Utilisez uniquement des pièces et des appareils conformes à la législation et aux normes qui
s’appliquent.
L’actionneur de la borne de sortie peut être branché en monovoie. Afin de maintenir les niveaux de
sécurité, gainez les câbles de signal séparément ou installez-les dans un espace protégé comme à
l’intérieur du boîtier de commutation afin d’éviter des courts-circuits avec les autres signaux.
●
En cas de problème, tel qu’un accident ou des dommages sur un appareil, arrêtez immédiatement le
système et assurez la sécurité. Recherchez et supprimez la cause du problème avant de refaire
fonctionner le système.
Summary of Contents for MITSUBISHI ELECTRIC MELSEC iQ-F FX5
