16
[PRÉCAUTIONS DE CABLAGE]
ATTENTION
●
Connectez le connecteur
d’alimentation et le bornier à un circuit isolé des tensions dangereuses au moyen d’une isolation
double ou renforcée.
●
Effectuez une mise à la terre de classe D (résistance à la mise à la terre : 100
Ω
ou moins) du module
d’extension de sécurité.
Faute de quoi, il y a un risque d’électrocution et de dysfonctionnement.
●
Vérifiez la tension nominale et la disposition des bornes avant d’effectuer le câblage afin de connecter
le module correctement.
Connecter le module de façon incorrecte ou à une tension différente peut provoquer un feu ou une
panne.
●
Serrez les vis des bornes au couple de serrage indiqué.
Des vis de bornes mal serrées peuvent provoquer un court-circuit, un feu ou un dysfonctionnement.
Des vis de bornes trop serrées peuvent endommager les vis et le module et provoquer une chute, un
court-circuit ou un dysfonctionnement.
●
Le module d’extension de sécurité doit être installé et utilisé dans un boîtier de commutation. Le câble
d’alimentation principal connecté au module d’extension de sécurité installé dans le boîtier de
commutation doit passer par un bornier relais.
Le remplacement de l’alimentation et le câblage doivent être réalisés par un technicien de
maintenance suffisamment formé à la prévention des risques d’électrocution. Voir Page 89 WIRING
pour la méthode de câblage.
●
Dans les environnements stricts concernant les niveaux de bruit, prenez des mesures externes de
prévention du bruit, telles que l’installation d’un parasurtenseur ou d’un cœur de ferrite.
Summary of Contents for MITSUBISHI ELECTRIC MELSEC iQ-F FX5
