Shibaura SG280E, Workshop Manual

Page: 21 / 111

18
13. Removing the cam shaft assembly
1) Remove the anchor bolts from the plate .
* Remove one of the bolts after aligning it with the
gear hole.
[the hole indicated by the arrow
in the figure on
the right]
2) Pull the cam shaft out of the cylinder block.
14. Removing the suction filter and pipe
1) Remove the oil pan.
2) Remove the bolt
, and then remove the suction filter
and pipe .
15. Removing the connecting rods and pistons
1) Remove the bolts , and then remove the rod cap .
2) Pull the connecting rods and pistons out as a single unit
from the cylinder head, and store them after confirming
the rod caps and markings.
CAUTION:
1. Remove the carbon around the upper dead
center of the cylinder before removing these
parts.
2. Arrange the removed rods and pistons in the
order of the cylinders. [so they can be
assembled again in the same order]
16. Removing the crank shaft assembly
1) Remove the flywheel cover and rear oil seal .
Fig.2-4-20
Fig.2-4-17
Fig.2-4-18
Fig.2-4-1