Shibaura SG280E, Workshop Manual

Page: 19 / 111

16
8. Removing the tappet
Pull the tappets up and out of the cylinder block.
9. Removing the injection pump assembly
1) Remove the engine stop solenoid .
2) Remove the bolts and nuts holding the injection
pump .
3) Slowly lift the injection pump over the stud bolts ,
and then pull out the snap pin and remove it from the
link .
CAUTION: Check the number and thickness of
shims inserted on the installation
surface for injection.
Fig.2-4-10
Fig.2-4-11
Fig.2-4-12
Fig.2-4-9