92
6. Cardin shaft
and intermediate plate
1) Pull out the Cardin shaft
.
2) Remove the intermediate plate
.
7. Taper shaft
1) Turn over the bearing housing, and then use a
hydraulic press to pull the shaft
and taper
bearing
out of the housing, together as a single
unit.
2) Pull the shaft seal
and dust seal
out of the
bearing housing, and assemble them in the
orientation shown in the figure on the right.
Fig.5-4-34
CAUTION:
1. Pay careful attention to the orientation of the
seal ring
in the intermediate plate when
replacing it.
(See the figure on the right.)
2. If there is a difference in level between the rotor
and the contact surface, replace it with the
motor assembly.
Fig.5-4-35
Fig.5-4-36
Fig.5-4-37
CAUTION:
Apply grease to seals before assembly.
Summary of Contents for SG280E
