81
<
<
<
<<
<
<
<
3. Adjusting stop distance
>
>
>
>>
>
>
>
The distance until stopping is adjusted by the strength
of the spring
. [Adjust the distance from full speed
with the sub-transmission in High until a complete stop
at from
5 to 10m
.]
See Fig. 5-3-13.
7. Adjusting the HST neutral switch
Adjust neutral before performing this procedure.
(1) Separate the wiring
for the safety switch, loosen
the two installation bolts
on the switch bracket
,
and then adjust by sliding the bracket
so that
electricity flows when the HST pedal is in the
neutral position.
(2) Connect the switch wiring, and confirm that the
engine does not start if the HST pedal is pressed
forward or reverse (a state other than the neutral
position).
Pedal
Speed (km/h)
Forward
0 to 9 (4WD)/0 to 18 (2WD)
Reverse
0 to 6 (4WD)/0 to 12 (2WD)
Fig.5-3-14
Fig.5-3-15
Summary of Contents for SG280E
