Shibaura SG280E, Workshop Manual

Page: 106 / 111

102
2) Tie rod lock nut tightening torque
This is an important safety part. Use the rated torque
when tightening.
3. Front tire tightening torque and air pressure
4. Front tire turning angle
Adjust the rated angle by adjusting the stopper bolt.
5. Adjusting the clutch belt
1) Centering the pulley
Adjust the washers (2mm/washer) so that the pulley
is centered on the engine side. [Use up to 2
washers.]
2) Press the center of the belt at 49N (5kgf), and adjust
the lock nut on the wire to create a sag of about
10mm.
[Perform this procedure with the clutch lever set to
ON.]
Tie rod lock nut tightening torque
131 to 163N
⋅⋅⋅⋅
m (13.4 to 16.6kgf-m)
Front tire tightening
torque
Air pressure
79N
⋅⋅⋅⋅
m (8.1kgf-m)
6.86MPa (0.7kgf/cm
2
)
Front tire turning angle
43
± ± ± ±
2deg (inner) 32
± ± ± ±
2deg (outer)
Fig.5-6-16
Fig.5-6-17
Fig.5-6-14
Fig.5-6-15
Lock nut
Lock nut