99
2. Removing the front axle
* Remove the front link and universal joint on the
mower before proceeding with this work.
1) Remove the battery cable
(+, -), and then remove
the battery
.
2) Remove the V belt
that drives the PTO shaft.
[Remove the upper
and lower
belt covers.]
3) Use a stand to raise the front of the frame, and then
remove the front tires.
4) Remove the nut
and spring washer
from the front
of the PTO shaft drive, and then remove the pulley
and plate
together as a single unit.
[Remove the grease nipple
first.]
5) Pull out the pins
on both ends of the power steering
cylinder, and then separate the cylinder
from the
tie rod
and front axle
.
Fig.5-6-4
CAUTION:
Use a swing stopper (such as a wood block) to
prevent the front axle from swinging.
(See the figure on the right.)
CAUTION:
Remove the hydraulic hose with separating it.
Fig.5-6-2
Fig.5-6-3
Fig.5-6-5
Summary of Contents for SG280E
