Sharp MX 3501N - Color Laser - Copier, Service Manual

Page: 247 / 448

MX3500N SIMULATION 7 – 139
<Detailed description for each print pattern in item A>
65
65-1
Purpose Adjustment
Function (Purpose) Used to adjust the touch panel (LCD dis-
play section) detection position.
Section Operation panel
Item Adjustment
Operation/Procedure
1) Touch the four cross marks on the screen. The coordinates of
the pressed points are set.
* The four cross marks may be touched in any sequence.
* A touched cross mark grays out.
* When all the four marks are touched and in the case of OK,
the sampled correction value is saved and the display
returns to the sub number entry screen.
In the case of NG, the display returns to the initial screen.
* The correction value sampled by this simulation and the
coordinates of sampled positions are used to obtain the
coordinates from the correction values of the touched posi-
tion.
65-2
Purpose Adjustment/Setup/Operation data output/
Check (Display/Print)
Function (Purpose) Used to check the touch panel (LCD dis-
play section) detection position adjustment
result.
Section Operation panel
Item Operation
Operation/Procedure
1) Enter the simulation.
When the touch panel is not touched at all, the coordinates of
X and Y are "0."
2) Touch the touch panel.
The coordinates of the currently touched position are dis-
played in real time.
* X-coordinates (horizontal direction) and Y-coordinates (verti-
cal direction) are displayed in decimal numbers.
* When you take your finger off the touch panel, the last dis-
play value is displayed. (It does not return to "0.")
* As far as the touch panel is properly adjusted, the range of coor-
dinates in the LCD display range is:
X-axis: "0" to "639"
Y-axis: "0" to "239"
67
67-24
Purpose Adjustment
Function (Purpose) Use to execute the printer setting of auto
color calibration.
Section Printer
Item Setting
Operation/Procedure
1) When the machine enters Simulation 67-24, the following
screen is displayed.
* When [EXECUTE] button is pressed, the high density pro-
cess control is started and the 48-patch self-printing is
started.
Check to confirm that there is A3 paper in the paper feed
tray. If paper is insufficient, supply it.
2) During the 48-patch self-printing, [EXECUTE] button is high-
lighted.
3) After completion of self-printing, the display is shifted to the
output patch scan start standby screen.
NO. Content
Color select Gradation select
dither select
Remark
Condition When NO
1 PS inspection pattern (COLOR) 1:Straight
2:Calibration
2 PS inspection pattern (B/W) K only 1:Straight Rounded to K only regardless of COLOR SELECT status.
Print is made at the B/B mode process speed.
2:Calibration
0
K
A:
A
㧦
1
B
㧦
2
C 㧦 1
D 㧦 2
㧧 PRINT PATTERN
㧧
DITHER
㧦
CALIB
㧧 MULTI COUNT
㧧 PAPER 㧦 CS1
SIMULATION NO.64 㧙 06
PRINTER SELF PRINT 㧔 PS 㧕
1
㨇 1 㨪 2 㨉
C M
Y
OK
TEST
EXECUTE
CLOSE
X 㧦 0 Y 㧦 0
20
40
40
40
200
120 220 320 420 520 620
600
40
600
200
70
120
170
220
20