Sequential PRO 3, User Manual

Page: 57 / 168

45 Pro 3 User’s Guide Low Frequency Oscillators
Sync:
When on, the LFO synchronizes with the master clock, which
controls the Arpeggiator, Sequencer, and certain effects.
Amount:
Sets the amount of LFO modulation routed to the selected
destination. Setting an amount here applies the selected modulation
continuously. You can also use the modulation matrix to route an LFO to
additional destinations and use a different modulation amount.
TAB 2 - LFO Control
SLEW RATE
Slew Rate Wave Reset Phase
LFO Dest
PHASE
0 0
WAVE RESET
LFO Control LFO Shape
Slew Rate:
0...127
—Slew adds a smoothing effect to a control param-
eter by affecting its rate of change. You can think of it as glide/
portamento for control voltages. For example, if you apply a high
slew rate
value to the LFO’s pulse wave, its sharp-edges will
be smoothed and it will become more like a sine wave. The same
is true when applied to the
s
&
h
/
random
LFO waveshape: the abrupt
changes will be smoothed.
Phase: 0...127
—Use Phase to offset the LFO waveshape’s start point.
For Phase to have any noticeable effect,
wave reset
must also be enabled
for that LFO. If the LFO is free-running—that is, with
wave reset
off—
there is no fixed start point from which the phase can be offset. This is
useful for modifying the shape of the chosen LFO waveshape.
Wave Reset: Off, On
—When off, the LFO is free running. When on,
the LFO is re-started each time a new note is played.
wave reset
is set
independently for each LFO. This is useful if you want to ensure that the
full waveshape is applied each time you strike a key.