Sequential PRO 3, User Manual

Page: 111 / 168

99 Pro 3 User’s Guide Global Settings
In
passthru
mode, turning the pot has no effect until after the edited
value equals the preset value (that is, until the edited value “passes
through” the stored value).
jump
mode uses an absolute value based upon the position of the pot
when edited: turn a pot and the value jumps immediately from the stored
value to the edited value.
20 . Footswitch Polarity: Normal, Reversed—
There are two types of
momentary footswitches, normally open and normally closed. Either
type can be used with the Sustain switch input. This setting allows you
to accommodate both models in case yours behaves in a way that is
the opposite of what you expect due to its polarity. (Sustain is on until
the footswitch is pressed and then it turns off, which is the opposite of
the expected behavior.) Connect your pedal and choose the appropriate
setting based on its behavior.
21 . Footswitch Function: Sustain, Arp Hold, Arp Hold Mom—
Sets the
function for the Sustain pedal input the rear of the synthesizer. Select-
ing
sustain
chooses normal sustain pedal operation. Selecting
arp hold
and pressing the sustain pedal causes the Arpeggiator to hold the current
arpeggio as if you had pressed the hold button on the front panel. Select-
ing
hold mom
causes the Arpeggiator to sustain (even when you release
the notes on the keyboard) for as long as you hold down the pedal.
Releasing the Sustain pedal stops the Arpeggiator.
22 . Pedal Polarity: Normal, Reversed—
There are two types of pedals,
normally open and normally closed. Either type can be used with the
Sustain switch input. This setting allows you to accommodate both
models in case yours behaves in a way that is the opposite of what you
expect due to its polarity. Connect your pedal and choose the appropriate
setting based on its behavior.
23 . Pedal Function: LPF Full, LPF Half—
When you use an expression
pedal connected to the
pedal
jack to control filter cutoff, this sets the
range of modulation sent. With
lpf full
selected, an expression pedal
connected to the
filter
jack will control filter cutoff frequency within its
full range of 0-1019 (fully closed to fully open). With
lpf half
selected,
an expression pedal connected to the
filter
jack will control filter cutoff
frequency within half of its range (fully closed to half open).