The
Firmware
section allows you to
tell the slicing engine about the firmware
you're using with your Orion.
Z Can Be Negative
can be checked if
the firmware you're using on your Orion will
accept Z positions below zero. Leave this unchecked if you're using the stock Orion firmware.
G-Code Output
specifies what “flavor” of G-Code should be created by the slicing
engine. For the Orion, this should be set to
REPRAP
.
The next page is called
Custom
G-Code
and allows you to customize the
code sent for five different print events.
Unless you're familiar with what the listed
G and M codes do, please don't modify
the defaults shown.
Start G-Code
is inserted into the
G-Code output right after the temperature
setting. If you have the commands to set
the temperatures in this section, they
won't be generated outside of this section.
You can also include values from other
sections such as “first_layer_temperature”
End G-Code
is inserted into the
output at the very end, after all print
operations have been completed.
Pause G-Code
is sent when the
Orion is paused during a print.
Resume G-Code
is sent when the
Orion is resumed.
Cancel G-Code
is sent when you
cancel a print job from MatterControl
85
