the part looks like from the side. You can easily see the support material as well as the layer
lines that will be at a 30 degree angle when the little cube is laid flat.
Support material is generated in such a way that there is just enough of it there to handle
the actual print layer that it will be supporting. In my example, the support material has a 2.5mm
spacing between the walls of support material and it uses an infill angle of 45 degrees.
The printed part will usually separate from the support material fairly easily – however,
some material will be left behind if you're using a raft. Cleaning up the left over support material
is a simple and straightforward task.
52