After the machine is homed, scroll to “Z Position” and click.
You'll see the display change to what is similar to the photo above. In order to move the
platform down, you'll turn the knob counter-clockwise. If you turn it quickly, you'll get large
movements and when you turn it very slowly, you'll get a .01mm per-click change.
Use the knob to lower the platform so that the nozzle tip is about 1/2” above the glass
build surface.
Make sure the nozzle is clean and there is no filament hanging from the nozzle (Be
careful, it’s hot now!). Take a single sheet of notebook paper and place it under the nozzle.
Turn the knob slowly and jog down until the nozzle just begins to “snag” on the paper.
Now press the knob to return to the menu and scroll down to “Set new Z=0.00” to store the new
Z height to memory. That’s it! You’ve now set the Z height to the table and you're now ready to
prime the hot end and begin your first print!
26
