Savch S3100E Series, User Manual

Page: 103 / 150

99
Bit11 PULSE Input pulse freuency(Hz)
Bit12 Communication setting value
Bit13 Reserved
Bit14 Main frequency X display (Hz)
Bit15 Auxiliary frequency Y display (Hz)
If the above parameters need to be displayed during operation, set the
corresponding position to 1, set the binary number to hexadecimal and set it to
08-04.
Running display parameters are used to set the parameters that can be viewed when the inverter is in running
state.
The maximum number of status parameters available for viewing is 32, and the status parameters to be displayed
are selected according to the binary bits of the 08-03 and 08-04 parameter values. The display order starts from
the lowest bit of 08-03.
08-05
LED shutdown display parameters

Factory setting
33
Setting range
0000
～
FFFF
Bit00 Setting frequency(Hz)
Bit01 BUS voltage(V)
Bit02 MI input status
Bit03 MO output status
Bit04 AVI1 voltage(V)
Bit05 AVI2/ACI voltage(V)
Bit06 Reserved
Bit07 Count value
Bit08 Length
Bit09 PLC stage
Bit10 Load speed
Bit11 PID setting
Bit12 PULSE input pulse frequency(kHz)
If the above parameters need to be displayed during operation, set the
corresponding position to 1, set the binary number to hexadecimal and set it to
08-05.
08-06 Load speed display coefficient
Factory setting 1
Setting range 0.0001 ～ 6.5000
When the load speed Load speed needs to be displayed, this parameter is used to adjust the corresponding
relationship between the inverter output frequency and the load speed Load speed. Refer to the instructions of
08-12.
08-07 Reserved
Factory setting -